Stainless steel mail box. All parts were plasma cut. *

Aluminum hinged ramp. *

Mustang body front end rotisserie stand. Yes, there is a rear stand. These were made for Mustangs and More

Peterbuilt cab support beam. All parts were plasma cut.

Aluminum synthesizer case for Gary Chang. End plates were plasma cut.

Troll motor mount for all-terrain vehicle attached to winch mount.

Computer enclosure for PC that runs the plasma cutter. the plasma cutter cut out the front, back panels and door.

The Condor Sanctuary flight enclosure needed an anti-bear door made. This shows the start of the project. The parts on the door will make up the latch assembly.

The anti-bear door got a little warped in the fire a couple of years back. I straightened it out and got it ready for use agian.

The assembly shown was to be a custom bearing mount for a farm disking machine. Joe Terry did the fabrication.

1965 -66 Mustang clutch pedal assembly. These are made for Mustangs and More

Stainless ratchet wrench for meter work.

This was made to clamp to a window sill of a small airplane. A camera is mounted inside the box with the lens looking through a 3" cover lens set in the bottom of the box. It will be used in Africa to take digital photos of Elephant hapitat. The plane will be flying at 300 feet. On this particular job there was no time to sand welds and make it pretty.

This is 1 of 2 Stainless Steel monitor enclosures that went to a drill rigg in the Ural Mountains between Europe and Asia.

This is the back side. The cables and gear have to be sealed in the box. The bent rods are to store the power cable in transit. The finish I put on the panels is a hand done large engine turning look.

These are 2 of 4 turbo chargers fitted with stainless steel water jackets.

These are the inner cooler housings for the turbo chargers.